Made In The USA

Proud Sponsors Of:
Team Boss Racing - Winnipeg CA
Team Bauerly Racing
Kourtney Hungerford Snowmobile Freestyle
Sam Rogers Freestyle

Powder Kits / Vent Cover Installation Page


Items You May Need

  • Alcohol based cleaning solution
  • towel
  • Low watt heat gun or hair dryer
  • Scissors

Peel/Stick Products Installation Instructions


  • MAKE SURE YOU COMPLETE THE FOLLOWING WORK IN ROOM TEMPERATURE.
  • Lay the cover onto your snowmobile hood, take a moment to view how the Vent Cover will be applied to your type of hood. You may also use some masking tape to make reference marks for easier installation when you are ready to apply the adhesive to your hood.
  • Starting at a reference point or corner of your Vent Cover, one strip at a time, begin to remove the adhesive backing, making sure you place the cover in the correct position, DO NOT PUT PRESSURE ON THE ADHESIVE yet, you will be able to lift and replace the adhesive if necessary to ensure a good fit.
  • After you have placed the Vent Cover on your snowmobile hood, removed the adhesive backing from all of your strips, and your Vent Cover is in its final position, apply pressure to the Vent Cover by using your hand to ensure the adhesive backing has sufficient pressure.
  • After slight presuure, apply heat with either a low watt heat gun or a hair dryer, make sure not to get your heat source too close to your vent cover, start to apply heat & more pressure. The combonation of heat & pressure is what adheres our products to your hood.

Velcro® Products Installation Instructions


  • MAKE SURE YOU COMPLETE THE FOLLOWING WORK IN ROOM TEMPERATURE.
  • Place the Vent Cover on a table with the Velcro side up.
  • With scissors, begin to cut the lengths needed from the roll of Velcro provided, do not remove the adhesive backing yet. Make sure you are trimming the edges of the Velcro to precisely match the Vent Cover itself to ensure a clean look when applied to your snowmobile hood.
  • Once you have trimmed your Velcro strips and they are affixed to the Vent Cover, turn your Vent Cover over and lay it onto your snowmobile hood, take a moment to view how the Vent Cover will be applied to your type of hood. You may also use some masking tape to make reference marks for easier installation when you are ready to apply the adhesive Velcro to your hood.
  • Starting at a reference point or corner of your Vent Cover, one strip at a time, begin to remove the adhesive back from the Velcro, making sure you are place the Velcro in the correct position, DO NOT PUT PRESSURE ON THE VELCRO, you will be able to lift and replace the Velcro if necessary.
  • After you have placed the Vent Cover on your snowmobile hood, removed the adhesive backing from all of your strips, and your Vent Cover is in its final position, apply pressure to the Vent Cover by using your hand to ensure the adhesive backing has sufficient pressure.